Wiring Diagram For The Radar Sensors Control Unit - PE30.30-P-2102-97FBA
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2023 Mercedes-Benz C43 AMG, 2022 Mercedes-Benz C43 AMG, 2021 Mercedes-Benz C43 AMG, 2020 Mercedes-Benz C43 AMG, and 2019 Mercedes-Benz C43 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Engine 177, 274, 276, 626, 651 in model 205 up to model year 2019 with code 233 (DISTRONIC PLUS) Control unit N62/1 Engine 177, 274, 276, 642, 651 in model 253 (except 253.99) up to model year 2020 with code 233 (DISTRONIC PLUS) Control unit N62/1
| Code: | Designation: | Position: |
|---|---|---|
| AO | Use of wiring diagrams | 48L |
| B92 | Front long-range radar sensor | 8L |
| B92/1 | Center rear bumper radar sensor | 45L |
| B92/10 | Left outer rear bumper radar sensor | 37L |
| B92/3 | Left front bumper radar sensor | 22L |
| B92/4 | Right front bumper radar sensor | 26L |
| B92/7 | Right outer rear bumper radar sensor | 40L |
| CAN S2 | Radar CAN 2 | 46K |
| CAN S2 | Radar CAN 2 | 43K |
| CAN S2 | Radar CAN 2 | 36K |
| Code 237 | Active Blind Spot Assist | 30A |
| Code 238 | Active Lane Keeping Assist | 30A |
| Code 253 | Rear-end collision warning and protection system | 30B |
| F1/3 | Passenger-side A-pillar fuse box | 3L |
| F1/3f337 | Fuse 337 | 1K |
| Flex E | Chassis FlexRay | 17K |
| K40/5 | Rear fuse and relay module | 13L |
| K40/5 | Rear fuse and relay module | 33L |
| K40/5f452 | Fuse 452 | 31L |
| K40/5f453 | Fuse 453 | 29L |
| K40/5f456 | Fuse 456 | 12L |
| N62/1 | Radar sensors control unit | 4A |
| N62/1 | Radar sensors control unit | 12A |
| N62/1 | Radar sensors control unit | 21A |
| N62/1 | Radar sensors control unit | 29A |
| N73 | Electronic ignition switch control unit | 17L |
| W16/4 | Right major assembly compartment ground point | 28L |
| W16/4 | Right major assembly compartment ground point | 8E |
| W3/8 | Right rear wheel well ground point | 31E |
| W52/6 | Right center longitudinal member ground point | 3E |
| X18 | Cockpit wiring harness and frame floor assembly electrical connector | 17E |
| X26/38 | Front bumper and frame wiring harness electrical connector | 19E |
| X26/40 | Rear frame floor assembly/bumper electrical connector | 33E |
| Z36/16z1 | Front sensor CAN (low) connector sleeve | 20G |
| Z36/17z1 | Rear sensor CAN (low) connector sleeve | 43E |
| Z36/18z1 | Front sensor CAN (high) connector sleeve | 19G |
| Z36/19z1 | Rear sensor CAN (high) connector sleeve | 41E |
| Z36/26z1 | DISTRONIC PLUS front ground line connector sleeve | 23G |
| Z36/27z1 | DISTRONIC PLUS front power supply connector sleeve | 22G |
| Z36/35z1 | Rear bumper circuit 15 connector sleeve | 40G |
| Z36/36z1 | Rear bumper circuit 31 connector sleeve | 39G |