Remove/Install Steering Column Module - AR54.25-P-2802EW
Model 166, 172, 212, 218, 292
Shown on model 212
Shown on model 212
| Remove | |||
| 1 | Remove steering wheel | AR46.10-P-0100EW | |
| 2 | Pry off steering column tube cover (5) from steering column tube module (1) at catches (arrows) | Model 212, 218 | |
| Fig 2 | |||
| 3 | Remove steering column tube module (1) from steering column tube | Do not operate the red safety catches in the steering column tube module (1). Otherwise irreparable damage will be caused to the fanfare horns and airbag clock spring contact. |
|
| 4 | Unclip cable duct with electrical line from frame of steering column tube cover (5) | Model 212, 218 | |
| 5 | Disconnect electrical connection from steering column tube module (1) and remove steering column tube module (1) | AR54.25-P-2802-02CW | |
| Install | |||
| 6 | Clip cable duct with electrical line into frame of steering column tube cover (5) | Model 212, 218 | |
| 7 | Connect electrical connection to steering'" column tube module (1) and position steering column tube module (1) | ||
| 9 | Break off transport protection (2) | When installing a new steering column tube module (1). | |
| 10 | Press steering column tube cover (5) onto steering column tube module (1) | Model 212, 218 | |
| 11 | Install steering wheel | AR46.10-P-0100EW | |
| Initial startup | |||
| 12 | Perform initialization of DTR control unit | The DTR control unit is only initialized after the steering column tube module (1) has been replaced. | |
| AD00.00-P-2000-04A | |||
| 13 | Perform initial startup of steering column tube module (1) | Only when replacing steering column tube module (1). | |
| AD00.00-P-2000-04A |