Press In Guide Sleeve - AR41.10-P-0200-03W
MODEL 172
CHECK VALUES FOR PROPELLER SHAFT ALIGNMENT SLEEVE
| Number | Designation | Model 172.447/448 | Model 172.403/457 | Model 172.475 | ||
|---|---|---|---|---|---|---|
| BE41.10-P-1001-02E | Insertion dimension "a" from face end of alignment sleeve to joint flange | Front propeller shaft | mm | 23.3 | 24.8 | 22.4 |
| Rear propeller shaft | mm | 26.8 | 28.3 | 25, 9 | ||
| See picture | - | - | - |
- Use a suitable drift to drive in the new guide sleeve.
Observe press-in dimension (a) from the end face of the centering sleeve to the flange.
The specified press-in distance (a) may deviate depending on the thickness of the flexible couplings, e.g. in vehicles with vibration damper. In these cases the dimension (a) measured prior to removal should be used for installation.