Remove/install rear axle pressure reservoir - AR32.50-P-0011RX

MODEL 230.456/458 with CODE (487) Active Body Control (ABC) 

MODEL 230.470/471/472/477 

MODEL 230.479 as of model year 2006 

MODEL 231 with CODE (487) Active Body Control (ABC) 

Fig 1: Rear Axle Pressure Reservoir Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Notes on fitting hydraulic lines and hoses		AH32.50-P-0001-02A
	Before opening the hydraulic system, thoroughly clean the area surrounding the separation point. Even the smallest dirt particles, introduced into the hydraulic components, can lead to malfunctions and a total failure of the hydraulic system
	Notes on Active Body Control suspension		AH32.50-P-0001-01N
1	Remove rear axle ABC valve unit (Y36/2)	Model 230	AR32.50-P-0002RX
		Model 231	AR32.50-P-0002RK
2	Remove bolt (3) and remove hydraulic line (8) from pressure reservoir (2)	Detach hydraulic line (8) at the earliest 10 minutes after switching off the engine, as only then is the ABC system completely unpressurized. Check sealing rings for damage and replace if necessary. Check support rings for damage and if necessary replace the complete hydraulic line (8).
	Model 230		*BA32.50-P-1027-01A
		Model 231	*BA32.50-P-1011-01C
3	Unscrew nuts (4) and remove pressure reservoir (2)	If necessary: ↓
	Dispose of pressure reservoir.			OS32.30-P-0620-01A
		Model 230	*BA32.50-P-1025-01A
		Model 231	*BA32.50-P-1008-01C
4	Install in the reverse order
5	Fill and bleed ABC system	Model 230	AR32.50-P-0021N
		Model 231	AR32.50-P-0021SX