Remove/install HERMES control unit - AR82.95-P-0019RKM

MODEL 231 

with CODE 360 (HERMES UMTS) 

MODEL 231 

with CODE 362 (HERMES LTE) 

Fig 1: HERMES Control Unit Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Connect diagnostic system and carry out initial startup of HERMES control unit (1)	When replacing HERMES control unit (1).
2	Switch off ignition
3	Remove rear stowage box		AR68.30-P-7440RK
4	Separate electrical connectors (2)	Number of electrical connectors (2) can vary depending on equipment installed.
5	Remove nuts (3) and remove HERMES control unit (1)
6	Install in the reverse order