Remove/Install Torsion Bar On Rear Axle - AR32.20-P-0315LF

Model 217 

except code 487 (Active Body Control (ABC)) 

Model 222 

except code 487 (Active Body Control (ABC)) 

Fig 1: Torsion Bar On Rear Axle Components Location - Model 222 Except Code 487

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by pinching or crushing when working on springs or spring bodies that are under tension	Use only approved tensioning devices; additionally screen off hazardous area if necessary. Check special tools for damage and proper operation (visual inspection). Wear protective gloves.	AS00.00-Z-0001-01A
Notice	Notes on self-locking nuts and bolts		AH00.00-P-0001-01KOA
	Notes on repair work on suspension components		AH00.00-P-0100-01A
	Remove/install
1	Remove rear axle.		AR35.10-P-0010LF
2	Detach torsion bar linkage (1) from stabilizer bar (2)	Nut, torsion bar linkage to torsion bar	*BA32.20-P-1002-04R
3	Detach torsion bar (2) from rear axle carrier (3 and remove torsion bar (2)	Nut, torsion bar to rear axle carrier	*BA32.20-P-1001-04R
4	Check elastomer bearing (4) on torsion bar (2)	If damage is present ↓ Replace torsion bar (2)
5	Install in the reverse order