Remove/Install Rear Seat Cushion - AR91.12-P-1020LFA

Model 222.0/1/9 

with code 223 (Electric backrest adjustment and head restraints) 

Model 222.0/1/9 

with code 224 (Individual rear seats) 

Courtesy of MERCEDES-BENZ USA

Shown on left side of vehicle 

	Risk of injury.  Moving parts can pinch, crush or, in extreme cases even sever extremities.	No parts of the body or limbs should be within the operating area of mechanical components when moving components.	AS00.00-Z-0009-01A
	Remove/install
1	Move front seat as far forward as it will go
2	Move seat cushion (1) as far forward as it will go
3	Release seat cushion (1) and lift up far enough until the electrical connections (4, 5) can be disconnected	Reach under the seat cushion (1) (arrow A) and pull release lever (3) on seat frame (2) outwards. :  Ensure that sliders (arrows D) are seated correctly in guides (arrows C) of seat frame (2). The seat cushion (1) must latch audibly into the release lever (3) of the seat frame (2).
4	Remove electrical connectors (4, 5) from brackets (arrows B), release and disconnect	The number of electrical connectors (4, 5) differs depending on the vehicle equipment.
5	Remove seat cushion (1) from vehicle	Carefully remove seat cushion (1) from vehicle. Otherwise components of the vehicle may be damaged.
6	Install in the reverse order