Remove/Install Rear Engine Support - AR22.10-P-4360OIA
Engine 176, 177 in model 217, 222
Engine 656 in model 222
Shown on model 222 with engine 656
without code M005 (4MATIC)
Shown on model 222 with engine 176 with code M005 (4MATIC)
| Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Notice | Notes on threaded connections fastened using a tightening angle-based tightening process | AH00.00-P-0020-01A | |
| Notice | Notes on self-locking nuts and bolts | AH00.00-P-0001-01KOA | |
| Remove/install | |||
| 1 | Remove center and rear lower engine compartment paneling | AR61.20-P-1105LF | |
| 2 | Support and tie down automatic transmission (4) using major assembly support and mounting plate | ||
| 000 588 11 62 00 Major assembly mount | WS01.00-P-0092B | ||
| 000 588 10 62 00 Support plate | WS26.00-P-3309B | ||
| 3 | Unclip electrical line from engine carrier (2) | Engine 177 in model 217, 222 | |
| 4 | Remove exhaust system from engine carrier (2) | *BA49.10-P-1014-02E | |
| *BA49.10-P-1007-02N | |||
| *BA49.10-P-1009-02L | |||
| 5.1 | Unscrew bolts (1a) on engine carrier (2) | Engine 176, 177 in model 217, 222 except code M005 (Vehicles with 4MATIC/all-wheel drive) Engine 656 in model 222 except code M005 (Vehicles with 4MATIC/all-wheel drive) |
|
| *BA22.10-P-1004-03K | |||
| 5.2 | Unscrew nuts (1c) on engine carrier (2) | Engine 176, 177 in model 217, 222 with code M005 (Vehicles with 4MATIC/all-wheel drive) Engine 656 in model 222 with code M005 (Vehicles with 4MATIC/all-wheel drive) |
|
| *BA22.10-P-1004-03K | |||
| 6 | Lift up automatic transmission (4) with major assembly mount and mounting plate approx. 10 mm | ||
| 000 588 11 62 00 Major assembly mount | WS01.00-P-0092B | ||
| 000 588 10 62 00 Support plate | WS26.00-P-3309B | ||
| 7 | Unscrew bolts (2a) and remove engine carrier (2) downward | Engine 176, 177 in model 222 except code Z07 (B7 armoring on special protection version) Engine 656 in model 222 except code Z07 (B7 armoring on special protection version) Screw/bolt, rear engine support to frame floor assembly |
*BA22.10-P-1005-03K |
| 8 | Install in the reverse order |
ENGINE MOUNT, ENGINE SUPPORT (ENGINE SIDE)
| Number | Designation | Model 217 with engine 157, 176, 177, 278, 279 | Model 222 except code Z07 (B7 armoring on special protection version) | |
|---|---|---|---|---|
| BA22.10-P-1004-03K | Rear engine mount on engine support | Nm | 30 | 30 |
ENGINE MOUNT, ENGINE SUPPORT (ENGINE SIDE)
| Number | Designation | Model 222 with code Z07 (B7 armoring on special protection version) | |
|---|---|---|---|
| BA22.10-P-1004-03K | Rear engine mount on engine support | Nm | 30 |
ENGINE MOUNT, ENGINE SUPPORT (ENGINE SIDE)
| Number | Designation | Model 217 with engine 157, 176, 177, 278, 279 | Model 222 except code Z07 (B7 armoring on special protection version) | ||
|---|---|---|---|---|---|
| BA22.10-P-1005-03K | Screw/bolt, rear engine support to frame floor assembly | Stage 1 | Nm | 80 | 80 |
| Stage 2: Loosen | ∠ | - | - | ||
| Stage 3 | Nm | - | - | ||
EXHAUST SYSTEM
| Number | Designation | Model 217, 222 with engine 176 | |
|---|---|---|---|
| BA49.10-P-1007-02N | Bolt, cross connection to engine carrier | Nm | 20 |
EXHAUST SYSTEM
| Number | Designation | Engine 656 in model 222 | |
|---|---|---|---|
| BA49.10-P-1009-02L | Nut, decoupling element for front exhaust system to bracket | Nm | 20 |
EXHAUST SYSTEM
| Number | Designation | Engine 177 in model 217 | Engine 177 in model 222 | |
|---|---|---|---|---|
| BA49.10-P-1014-02E | Bolt, bracket for elastomer bearing for center exhaust system to engine carrier | Nm | 20 | 20 |