Tightening Specifications For Cylinder Head Bolts - AR01.30-P-5800-07MNA
Engine 176, 177, 178
| Topical note | Notes on threaded connections fastened using a tightening angle-based tightening process | AH00.00-P-0020-01A |
CHECK VALUES FOR CYLINDER HEAD BOLTS
| Number | Designation | Engine 176 | Engine 177 | ||
|---|---|---|---|---|---|
| BE01.30-P-1001-01A | Cylinder head bolt | Thread diameter | M | 11 | 11 |
| Length (L) when new | mm | 173 (-0, 8) | 173 (-0, 8) | ||
| Max. length (L) | mm | +1, 5 | +1, 5 | ||
CHECK VALUES FOR CYLINDER HEAD BOLTS
| Number | Designation | Engine 178 | ||
|---|---|---|---|---|
| BE01.30-P-1001-01A | Cylinder head bolt | Thread diameter | M | 11 |
| Length (L) when new | mm | 173 (-0, 8) | ||
| Max. length (L) | mm | +1, 5 | ||
CYLINDER HEAD
| Number | Designation | Engine 176 | Engine 177 | |||
|---|---|---|---|---|---|---|
| BA01.30-P-1001-01N | Bolt, cylinder head to crankcase | M7 | Nm | 15 | 15 | |
| M11 | Stage 1 | Nm | 40 | 40 | ||
| Stage 2 | ∠° | 90 | 90 | |||
| Stage 3 | ∠° | 90 | 90 | |||
| Stage 4 | ∠° | 90 | 90 | |||
CYLINDER HEAD
| Number | Designation | Engine 178 | |||
|---|---|---|---|---|---|
| BA01.30-P-1001-01N | Bolt, cylinder head to crankcase | M7 | Nm | 15 | |
| M11 | Stage 1 | Nm | 40 | ||
| Stage 2 | ∠° | 90 | |||
| Stage 3 | ∠° | 90 | |||
| Stage 4 | ∠° | 90 | |||
- Tighten cylinder head bolts
.
Do not retighten cylinder head bolts.
Observe tightening procedure, see tightening procedure.
If the tightening torque was exceeded on a cylinder head bolt.
↓
Remove cylinder head bolt, check shank length, replace cylinder head bolt if necessary and tighten starting with tightening stage 1.
Commercially available devices/tools
Vernier caliper