Remove/Install Right Rear Engine Suspension Lug - AR01.20-P-5012-02MNL
Engine 176 in model 217, 222
METRIC SCREWS/BOLTS AND NUTS AS PER MBN 10 105, 10 143
| Number | Designation | 8.8 | 10.9 | |
|---|---|---|---|---|
| BA00.10-P-1002-04A | M6 x 1 | Nm | 9 | 13 |
CYLINDER HEAD
| Number | Designation | Engine 176 | ||
|---|---|---|---|---|
| BA01.30-P-1003-01N | Bolt, heat shield/rear lifting eye to cylinder head | M6 | Nm | 9 |
- Remove screw/bolt (1)
.
- Open heat shield of the vacuum hose (2) at vacuum pump (6).
- Remove vacuum hose (2) from vacuum pump (6), seal openings with suitable stop plug
, and place vacuum hose (2) to one side.
- Remove screw/bolts (7)
- Unclip electrical line (3) from engine suspension lug (4).
- Remove screw/bolt/bolts (5)
- Remove engine suspension lug (4) upwards.
- Install in the reverse order.