(Retrofit Front Illuminated Door Sill Molding With Mercedes-Benz Lettering - AZ82.20-P-0005-10LFM)

Model 222.0 

as of model year 2018 

Installation is described on the right side of the vehicle. Installation at the left-hand side of the vehicle takes place in the same way.

1. Clean contact surface of right front door sill in the hatched area.

   Courtesy of MERCEDES-BENZ USA

2. Remove carrier foil (8) from the right front illuminated door sill molding (E17/48).

   Pay attention to guides (9) during subsequent installation.

   Courtesy of MERCEDES-BENZ USA

3. Position right front illuminated door sill molding (E17/48) on longitudinal member and press on evenly.
4. Connect black 2-pin connector of electrical line of right front illuminated door sill molding (E17/48) to black 2-pin connector of branch-off line of right front illuminated door sill molding (E17/48).

   Thus, the front right illuminated door sill molding electrical connector (E17/48x1) is created.

5. Fasten right front illuminated door sill molding electrical connector (E17/48x1) by means of a retaining clip onto longitudinal member.

   The retaining clip is included in the installation kit.

6. Route electrical line of right front illuminated door sill molding (E17/48) via body flange on longitudinal member and fix in place with adhesive tape (10).

Courtesy of MERCEDES-BENZ USA