Remove Pilot Bushing - AR41.10-P-0250-02LF

Model 217 

Model 222 

Measure 

1. Measure and note dimension (a).

   Courtesy of MERCEDES-BENZ USA

   Remove 

2. • 2.1  Knock pilot bushing (10) using flat chisel uniformly onto drive shaft (arrow).

     If the pilot bushings (10) are not seized.

     If the pilot bushings (10) are seized.

   • 2.2  15 mm from the end face of the pilot bushing (10), drill a hole (Ø 10 mm) at right angles through the centering sleeve (10).

   Courtesy of MERCEDES-BENZ USA

   Courtesy of MERCEDES-BENZ USA

3. Insert drift through hole and pry pilot bushing (10) out of drive shaft using two assembly levers.

   If the pilot bushings (10) are seized.

Courtesy of MERCEDES-BENZ USA