Remove/Install Hydraulic Pump Pulsation Damper - AR32.34-P-0013GQX
Model 166, 292 with engine 157, 278
with code 468 (ACTIVE CURVE SYSTEM)
Fig 1: Hydraulic Pump Pulsation Damper Components Location - Model 166 Engine 157; 278 With Code 468
| Risk of injury . Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Risk of injury to skin or eyes from hydraulic fluid spraying out under pressure. Risk of poisoning from swallowing hydraulic fluid. | Depressurize hydraulic system completely before starting any work on it. Wear protective clothing and safety glasses. | AS00.00-Z-0013-01A | |
| Notes on active roll stabilization | AH32.34-P-0001-01A | ||
| Remove/install | |||
| 1 | Open engine hood | ||
| 2 | Remove center section of engine cover | ||
| 3 | Unscrew pulsation damper (1) from hydraulic pump (2) | *BA32.00-P-1005-01A | |
| 4 | Install in the reverse order | ||
| 5 | Fill and bleed ACTIVE CURVE SYSTEM | AR32.34-P-0021GQ | |
| Clean | |||
| 6 | Clean the area around the pulsation damper (1) |
HYDRAULIC PUMP
| Number | Designation | Model 166 with engine 157 | Model 166 with engine 278 | |
|---|---|---|---|---|
| BA32.00-P-1005-01A | Pulsation damper to hydraulic pump | Nm | 45 | 45 |
HYDRAULIC PUMP
| Number | Designation | Model 292 with engine 157 | Model 292 with engine 278 | |
|---|---|---|---|---|
| BA32.00-P-1005-01A | Pulsation damper to hydraulic pump | Nm | 45 | 45 |