Remove/Install Engine Charge Air Channel Downstream Of Charge Air Cooler - AR09.41-P-8624CD

ENGINE 651 in MODEL 166, 172, 204, 207, 212, 218, 221 

Shown on MODEL 166 

Shown on MODEL 166 

	Remove/install
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by vehicle manufacturer.	AS00.00-Z-0010-01A
1	Remove throttle valve actuator (M166)	1	AR09.41-P-1321CD
2	Remove bottom sections of soundproofing	MODEL 166	AR61.30-P-1001GQ
		MODEL 172.4	AR94.30-P-5300W
		MODEL 204.0/2/3, 207, 212, 218	AR94.30-P-5300EW
		MODEL 204.9	AR61.20-P-1105CY
		Model 221 except code Z07 (Highest protection)	AR61.20-P-1105SX
3	Remove charge air hose to charge air duct (6)	To do this open coupling and detach charge air hose to charge air duct (6). Small oil quantities in the charge air hose come from the crankcase ventilation and are permissible. Check sealing ring (3) for damage and replace if necessary.	AR09.41-P-1311-01AL
4	Remove charge air temperature sensor (B178)	The charge air temperature sensor (8) must be replaced if there are defective snap-in brackets.	AR09.41-P-2002CD
5	Remove screw/bolt (5) and lead out charge air duct (6) to the rear	Slight quantities of oil in the charge air duct (6) come from the crankcase ventilation and are permissible. Check hose clamps (3) for damage; replace if necessary.
6	Install in the reverse order