Retrofit Illuminated Door Sill Molding Wiring Harness - AZ82.20-P-0001-04GQ

MODEL 166.0/8 

1. Disconnect yellow plug B (1) from rear control unit (N10/8).
2. Remove contact carrier for pin 1 to 26 from yellow connector B (1).
3. Plug line from left illuminated door sill molding wiring harness (2) into contact cavity 12 of contact carrier.
4. Plug line from right illuminated door sill molding wiring harness (3) into contact cavity 11 of contact carrier.
5. Reinstall contact carrier in yellow plug B (1) and connect to rear control unit (N10/8).
6. Connect ground cable (7) from illuminated door sill molding wiring harness to ground point (W17):
7. Route left illuminated door sill molding wiring harness (2) under left cable duct (4) and foam material (5) to left front footwell.
8. Clip black, 2-pin connector (6) from left illuminated door sill molding wiring harness (2) into cable duct.
9. Route right illuminated door sill molding wiring harness (3) under right cable duct (8) and foam material (9) to right front footwell.
10. Clip black, 2-pin connector (10) from right illuminated door sill molding wiring (3) into wiring harness.
11. Program interior lighting package.