Remove/Install Side Paneling In Trunk - AR68.30-P-4800GQ
MODEL 166.0
Shown on left side of vehicle
| Remove/install | |||
| 1 | Release backrest in rear and fold over | ||
| 2 | Remove load compartment cover | ||
| 3 | Remove support (7) | If installed. | |
| 4 | Remove load compartment floor (2) | Model 166.063 | AR68.80-P-5800GQA |
| 5 | Unscrew bolts (12) and remove rails (11) | Model 166.0 (except 166.063) | |
| 6 | Unscrew bolt (5) and remove rear center section paneling (6) | ||
| 7 | Remove storage compartment (4) | If installed. | |
| 8 | Remove lashing eyes (3) | ||
| 9 | Remove lashing eye (9) | *BA68.50-P-1002-03F | |
| 10 | Detach edge guard (8) on D-pillar in working area | ||
| 11 | Remove rear door sill (13) from C-pillar | AR68.30-P-4100GQ | |
| 12 | Detach edge guard (14) on C-pillar in working area | ||
| 13 | Unclip side paneling in left and right trunk (11, 1r) from D-pillar paneling | Figure | |
| 14 | Pull side paneling in right trunk (1r) out until electrical connector (10) is accessible | When removing side paneling in right trunk in right trunk (1r). | |
| 15 | Disconnect electrical connector (10) | When removing side paneling in right trunk in right trunk (1r). | |
| 16 | Remove side paneling in left and right trunk (1l, 1r) | ||
| 17 | Install in the reverse order |
CARGO RETAINERS
| Number | Designation | Model 166 | |
|---|---|---|---|
| BA68.50-P-1002-03F | Screw/bolt, tie-down eye to body/trunk floor | Nm | 24 |