Remove/Install Frontal Acceleration Sensor - AR91.60-P-0750GQ

MODEL 166, 292

Shown on model 166

G11970750

	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Disconnect battery ground line		AR54.10-P-0003GZ
2	Disconnect electrical connector (1)	The left frontal acceleration sensor (B48/1) or right frontal acceleration sensor (B48/2) are located on the inside of the front module and are accessible when the engine hood is open.
3	Unscrew nut (2)	Use new nut. Nut, frontal acceleration sensor to front module	*BA91.60-P-1021-01H
4	Remove left frontal acceleration sensor (B48/1) or right frontal acceleration sensor (B48/2)
5	Install in the reverse order

AIRBAG

Number	Designation		Model 166	Model 292
BA91.60-P-1021-01H	Nut, frontal acceleration sensor to front module	Nm	9	9