Retrofit Rear Entertainment Wiring Harness - AZ82.60-P-0015-02GQB

MODEL 166.0/8 

with CODE 866 (Preinstallation for rear entertainment system) 

Connection scheme 

Routing diagram 

Ensure that the wiring harnesses are not damaged by chafing or pinching.

Otherwise the corresponding wiring harness must be replaced.

The following operation steps are shown on the right side of the vehicle and they can be conducted analogously on the left side of the vehicle. The installation location for the screen and the screen number are to be clarified with the customer beforehand.

1. Connect white 2-pin plug (9.1) of wiring harness (power supply) (9) to white 2-pin connector (21) of vehicle wiring harness.

   The white 2-pin connector (21) was connected to the socket on the 2nd seat row at the right. The white 2- pin connector (9.2) is connected to the right 2nd seat row socket when the center console is installed.

2. Secure fuse carrier (9.4) using Velcro strip at floor covering below center console.
3. Route wiring harness (power supply) (9) from right 2nd seat row socket along existing lines below the floor covering and under the center console to the seat cushion frame and fix in place.
4. Fix wiring harness (power supply) (9) in place at seat cushion frame using cable ties.

   Fix the wiring harness (power supply) (9) in place at the seat cushion such that the seat can be adjusted without any restrictions.

   Otherwise shearing off or crushing of the wiring harness (power supply) (9) may occur.

5. Detach black 6-pin connector from front passenger seat connector block (X55/4) and strap down.
6. Plug black 6-pin connector (9.3) of wiring harness (power supply) (9) onto front passenger seat connector block (X55/4).
7. Connect white 8-pin connector (vehicle wiring harness) (10) to white 8-pin plug (8.1) of wiring harness (screen) (8).