Remove/Install Front Door Lining - AR72.10-P-1000GQS
MODEL 166 with CODE Z04 (Light armoring) with CODE Z05 (B5 armoring on special protection version)
| Remove/install | |||
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Notes on avoiding damage to windows installed in special high-security vehicles | AH67.00-P-0003-01FB | ||
| 1 | Switch off ignition and remove the transmitter key from the EIS [EZS] control unit | ||
| 2 | Unclip cover for bolt (1) and unscrew bolt | Figure | |
| 3 | Unclip door lining (3) from mounting clips (arrows) on front door (2) | Position assembly wedge directly on mounting clips (arrows). Otherwise, the retaining tabs on the mounting clips (arrows) can tear out of door liner (3). |
Figure |
| 4 | Horizontally loosen door lining (3) to side from front door (2). Guide lock button (4) out of door lining (3) | ||
| 5 | Disconnect electrical connectors (5, 6) from left front door control unit (N69/1) or right front door control unit (N69/2) | ||
| 6 | Unhook inside door opener Bowden cable (7) from inner door handle (8) | ||
| 7 | Remove door lining (3) | ||
| 8 | Install in the reverse order |