Remove/Install Front Door Lining - AR72.10-P-1000GQ
MODEL 166 except CODE Z04 (Light armoring) except CODE Z05 (B5 armoring on special protection version)
MODEL 292
Shown on model 166.004
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch on ignition and store transmitter key outside of transmission range (min. 2 m) | ||
| 2 | Remove cover from bolt (1) | Fig 1 | |
| 3 | Remove screw/bolt (1) | ||
| 4.1 | Unclip mirror triangle (12) | Model 166 except code 810 (Sound system) except code 811 (Advanced sound system) except code Z04 (Light armoring) except code Z05 (B5 armoring on special protection version) Model 292 except code 810 (Sound system) except code 811 (Advanced sound system) |
|
| 4.2 | Unclip mirror triangle (12) and disconnect electrical connector | Model 166 with code 810 (Sound system) except code Z04 (Light armoring) except code Z05 (B5 armoring on special protection version) Model 166 with code 811 (Advanced sound system) except code Z04 (Light armoring) except code Z05 (B5 armoring on special protection version) Model 292 with code 810 (Sound system) Model 292 with code 811 (Advanced sound system) |
|
| 5 | Remove window frame paneling (2) starting at mirror triangle | Fig 1 | |
| 6 | Pull pin (4) out of expansion rivet (3) with suitable pliers | ||
| 7 | Turn pin (4) 90° and press in expansion rivet (3) until it arrests | ||
| 8 | Grasp expansion rivet (3) with pliers on pin (4) and pull out of door lining (5) | ||
| 9 | Unclip door lining (5) at mounting clips (arrows) from front door (6) | Otherwise, the retaining tabs on the mounting clips (arrows) can tear out of door liner (5). |
|
| Fig 1 | |||
| 10 | Remove door lining (5) upward from front door (6) until sealing lip on door lining is detached from front door (6). | ||
| 11 | Horizontally loosen door lining (5) from front door (6) until electrical connectors (8, 9) on left front door control unit (N69/1) or right front door control unit (N69/2) and inside door opener wire (10) are accessible | ||
| 12 | Guide out release button (7) when detaching door lining (5) | ||
| 13 | Disconnect electrical connectors (8, 9) from left front door control unit (N69/1) or right front door control unit (N69/2) | ||
| 14 | Unhook inside door opening wire (10) from inner door handle actuation (11) | ||
| 15 | Remove door lining (5) | ||
| 16 | Install in the reverse order |