Removing And Installing Trim Panel At D-Pillar - AR68.30-P-4495GQX

MODEL 166.8 

MODIFICATION NOTES

13.06.2016

Operation steps and picture added

Operation steps 9, 10, picture P68.30-3932-05

	Remove/install
1	Remove side paneling in trunk		AR68.30-P-4800GQX
2	Move backrest of third seat row toward front
3	Lift cover (4) and unscrew bolt (2)	Bolt/nut, belt end fitting/seat belt buckle of 3rd seat row to body	*BA91.40-P-1011-01R
4	Remove seat belt (3) from floor
5	Remove airbag cover (9)	Mounting wedge	Figure
6	Unscrew bolt (10)
7	Pry off paneling (1) at rear (arrow)	Do not remove sealing weather strip (5) from body. Otherwise it can be damaged and must be replaced. Mounting wedge	Figure
8	Pull paneling (1) downward and to rear	: Guide retaining lug (7) into retaining plate and retaining lug (8) below headliner. Ensure that seal (6) and sealing weatherstrip (5) are seated correctly.
9	Install seat belt (3) and remove paneling (1)
10	Install in the reverse order

SEAT BELTS/EMERGENCY TENSIONING RETRACTORS

Number	Designation		Model 166
BA91.40-P-1011-01R	Bolt/nut, belt end fitting/seat belt buckle of 3rd seat row to body	Nm	35

Fig 1: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA