Remove/Install Anti-Roll Bar On Rear Axle - AR32.35-P-2210LWX
Model 253.388/389/988/989
| Notes on threaded connections fastened using a tightening angle-based tightening process | AH00.00-P-0020-01A | ||
| Notes on handling, transport and storage of ceramic brake disks | AH42.10-P-9406-13A | ||
| Notes on self-locking nuts and bolts | AH00.00-N-0001-01A | ||
| Notes on handling, transport and storage of composite brake disks | AH42.10-P-9406-12LF | ||
| Notes on AIRMATIC | Model 253.388/389/988/989 with code 489 (AIR BODY CONTROL) | AH32.22-P-1000-02LW | |
| Notes on repair work on suspension components | AH00.00-P-0100-01A | ||
| Remove | |||
| 1 | Remove rear axle | AR35.10-P-0010LWX | |
| 2 | Remove both torsion bar linkages (2) from stabilizer bar (1) | AR32.35-P-3329LWX | |
| 3 | Remove level sensors with brackets from rear axle carrier (3) and place to one side | AR82.10-P-0005LW | |
| 4 | Disassemble and remove stabilizer bar (1) from rear axle carrier (3) | ||
| Install | |||
| 5 | Check elastomer bearing (4) for damage and wear | If there are problems ↓ Replace stabilizer bar (1). |
|
| 6 | Mount stabilizer bar (1) onto rear axle carrier (3) | *BA32.20-P-1002-04T | |
| 7 | Mount level sensors with brackets onto rear axle carrier (3) | AR82.10-P-0005LW | |
| 8 | Mount both torsion bar linkages (2) onto stabilizer bar (1) | AR32.35-P-3329LWX | |
| 9 | Install rear axle | AR35.10-P-0010LWX |
REAR AXLE TORSION BAR
| Number | Designation | Model 253.388/389/988/989 | |
|---|---|---|---|
| BA32.20-P-1002-04T | Nut, torsion bar to rear axle carrier | Nm | 80 |