Remove/Install Adaptive Damping System Control Unit - AR32.32-P-0003LW
Model 205 with code 459 (DYNAMIC BODY CONTROL suspension with adjustment damping)
Model 205 with code 488 (Steel/air suspension)
Model 253 with code 459 (DYNAMIC BODY CONTROL suspension with adjustment damping)
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Commission adaptive damping system control unit (N51/5). | When replacing the adaptive damping system control unit (N51/5). | |
| AD00.00-P-2000-04B | |||
| 2 | Remove left front seat. | Model 205.0/1/2/3 with code 459 (DYNAMIC BODY CONTROL suspension with adjustment damping) Model 205.0/1/2/3 with code 488 (Steel/air suspension) Model 253 with code 459 (DYNAMIC BODY CONTROL suspension with adjustment damping) |
AR91.10-P-1000LW |
| Model 205.4 with code 459 (DYNAMIC BODY CONTROL suspension with adjustment damping) Model 205.4 with code 488 (Steel/air suspension) |
AR91.10-P-1000LWR | ||
| 3 | Remove electrical wiring harness (3) from air duct (1). | ||
| Fig 1 | |||
| 4 | Release air duct (1) (arrows A) and remove. | ||
| 5 | Carefully lift up floor covering (2). | ||
| 6 | Unclip adaptive damping system control unit (N51/5) from catch hooks (5) and pull out towards vehicle center (arrows B). | ||
| 7 | Disconnect electrical connectors (6) and remove adaptive damping system control unit (N51/5). | ||
| 8 | Install in the reverse order. |