Blind Spot Assist Wiring Diagram - PE54.71-P-2100-97FCB
Model 253 (except 253.99) as of model year 2020 with code 22P (Lane tracking package)
| Code: | Designation: | Position: |
|---|---|---|
| A0 | Use of wiring diagrams | 40L |
| B92/11 | Left outer rear bumper integrated radar sensor | 6A |
| B92/11 | Left outer rear bumper integrated radar sensor | 20A |
| B92/11 | Left outer rear bumper integrated radar sensor | 35J |
| B92/11 | Left outer rear bumper integrated radar sensor | 33A |
| B92/6 | Right outer rear bumper integrated radar sensor | 14A |
| B92/6 | Right outer rear bumper integrated radar sensor | 20A |
| B92/6 | Right outer rear bumper integrated radar sensor | 35G |
| B92/6 | Right outer rear bumper integrated radar sensor | 33A |
| CAN PER | Peripherals CAN | 9K |
| N10/8 | Rear SAM control unit | 5L |
| W7 | Right wheel house trunk ground point | 7L |
| X26/40 | Rear frame floor assembly/bumper electrical connector | 4H |
| X30/27 | Peripherals CAN (CAN PER) potential distributor electrical connector | 9L |
| Z36/17z1 | Rear sensor CAN (low) connector sleeve | 9E |
| Z36/19z1 | Rear sensor CAN (high) connector sleeve | 8E |
| Z36/35z1 | Rear bumper circuit 15 connector sleeve | 4F |
| Z36/36z1 | Rear bumper circuit 31 connector sleeve | 7E |