Remove/Install Left Or Right Rear Axle Speed Sensor - AR42.40-P-0820LW

Model 205 

Model 213 

Model 253 

Model 293 

Courtesy of MERCEDES-BENZ USA

Shown on model 205 

Shown on model 213 

Fig 1: Rear Axle RPM Sensor Components Location - Model 253; Shown on Model 213

Courtesy of MERCEDES-BENZ USA

	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
	Notes on handling, transport and storage of composite brake disks		AH42.10-P-9406-12LF
	Notes on handling, transport and storage of ceramic brake disks		AH42.10-P-9406-13A
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove/install
1	Remove rear wheel.		AR40.10-P-1102A
2	Release fender liner (1) in front area until electrical connector (3) is accessible and electric line (2) can be exposed.	Model 205, 253, 293	AR88.10-P-1400LW
3.1	Disconnect electrical connector (3) from rear axle left distributor electrical connector (X62/32) or rear axle right distributor electrical connector (X62/33).	Model 205 Model 253 Model 293
3.2	Unlock electrical connector (6) and remove from left rear axle RPM sensor (L6/3) or right rear axle RPM sensor (L6/4).	Model 213
4	Unscrew bolt (4).	Bolt, RPM sensor to wheel carrier	*BA42.30-P-1001-02K
5	Remove holder (5) from left rear axle RPM sensor (L6/3) or right rear axle RPM sensor (L6/4) and hook up to one side.	Model 205, 213, 253 (except 253.388/389/988/989), 293
6	Expose electric line (2) of left rear axle RPM sensor (L6/3) or right rear axle RPM sensor (L6/4) and remove left rear axle RPM sensor (L6/3) or right rear axle RPM sensor (L6/4).
7	Install in the reverse order.
8	Read out and erase fault memory using the vehicle diagnosis system.
		Model 205, 213, 253	AD00.00-P-2000-04B
		Model 293	AD00.00-P-2000-06FR