Glue Door Frame Seal To Rear Door - AR72.12-P-1015-01LWA

Model 205.0 

with code 700 (Technology Local Content China) 

Model 205.1 

Model 213 

Model 253 

Model 293 

Fig 1: Identifying Roller (168 589 05 63 00)

Courtesy of MERCEDES-BENZ USA

1. Remove spacer strip (1.1) by approx. 2 cm at one end of new sealing frame (1).
2. Before start of attachment, remove adhesive protective foil (1.3) from sealing frame (1) by a length of approx. 10 cm.

   Remove adhesive protective foil (1.3) in increments according to assembly progress.

   Otherwise the bonding foil can stick unintentionally or be soiled.

   Courtesy of MERCEDES-BENZ USA

3. Attach sealing frame (1) starting from center of lower door edge

   Spacer strip (1.1) of sealing frame (1) must be in contact with door paneling over entire length without gap.

4. Cut off sealing frame protrusion (1) at bottom edge of door and connect the two ends of the door frame seal (1).

   Cut off protrusion so that no gap subsequently arises between the two ends of sealing frame (1). Do not cut off protrusion at end of sealing frame (1) at which insert (1.2) protrudes.

   Courtesy of MERCEDES-BENZ USA

5. Firmly roll on sealing frame (1) using roller (9).
6. Fully remove spacer strip from sealing frame (1) starting at detached end.

Courtesy of MERCEDES-BENZ USA