Removing/installing ADS control unit - AR32.32-P-0500NKM
MODEL 117, 156, 176, 246 with CODE 459 (Steel suspension with adjustable damping)
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Commission ADS control unit (6) with XENTRY using Software Calibration Number (SCN) | When renewing the ADS control unit (6). | |
| AR54.21-P-0015X | |||
| 2 | Switch off ignition and keep transmitter key at a location beyond transmitter range (at least 2 m) | ||
| 3 | Remove passenger seat | Model 117, 156, 176 with code 459 (Steel suspension with adjustable damping) |
AR91.10-P-1000NKA |
| Model 246 with code 459 (Steel suspension with adjustable damping) |
AR91.10-P-1000NKB | ||
| 4 | Remove air duct (1) | ||
| 5 | Fold floor covering (2) towards rear | ||
| 6 | Unscrew nuts (3) | ||
| 7 | Remove bracket (4) with ADS control unit (6) and turn over | ||
| 8 | Remove bolts (5) | ||
| 9 | Remove ADS control unit (6) with connected electrical line (7) from bracket (4) | ||
| 10 | Move slide (8) up to end stop (arrow) and detach electrical connection | ||
| 11 | Install in the reverse order |