Remove/Install Stabilizer Bar On Front Axle - AR32.20-P-0300XG

Model 463 as of model year 2019 

Fig 1: Stabilizer Bar On Front Axle Components Location - Model 463 As Of Model Year 2019

Courtesy of MERCEDES-BENZ USA

	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
	Risk of injury.  Moving parts can pinch, crush or, in extreme cases even sever extremities.	No parts of the body or limbs should be within the operating area of mechanical components when moving components.	AS00.00-Z-0009-01A
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
	Notes on repair work on suspension components		AH00.00-P-0100-01A
	Remove/install
1	Remove center engine compartment lining.		AR61.20-P-1105XG
2	Remove torsion bar linkages (1).		AR32.35-P-3328XG
3	Unscrew bolts (2).	Bolt, torsion bar holder on front axle to frame	*BA32.35-P-1005-01A
4	Remove torsion bar (3).	Check torsion bar (3) and elastomer bearings (3.1). In the event of damage or wear. ↓ Replace torsion bar.
5	Install in reverse order.

STABILIZER BAR/TORSION BAR

Number	Designation		Model 463 as of model year 2019
BA32.35-P-1005-01A	Bolt, torsion bar holder on front axle to frame	Nm	95