Remove/Install Front Suspension Strut - AR32.25-P-1017GWX

Model 463.234 up to model year 2019 with code ZQ0 (G 500 4x42) 

Model 463.255 up to model year 2019 with code MUK2 (USA or Canada vehicle model designation) with code ZQ0 (G 500 4x4 ²  ) 

Model 463.274 up to model year 2019 with code LQ0 (G650 Landaulet) 

Fig 1: Front Suspension Strut Components Location - Model 463.255 With Code MUK2 Up To Model Year 2019

Courtesy of MERCEDES-BENZ USA

	Risk of injury.  Moving parts can pinch, crush or, in extreme cases even sever extremities.	No parts of the body or limbs should be within the operating area of mechanical components when moving components.	AS00.00-Z-0009-01A
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
	Remove/install
1	Remove front left and front right wheel and tire assembly.		AR40.10-P-1100GWX
2	Remove front left and front right fender liner.
3	Support front axle.	Support plate	Fig 2
		Major assembly mount	Fig 3
4	Remove screws (3).	Bolt, suspension strut to front axle/frame	*BA32.25-P-1001-04R
5	Lower front axle or raise vehicle until front suspension struts (1) can be pulled out of holders.	Support plate	Fig 2
		Major assembly mount	Fig 3
6	Pull suspension struts at front (1) left or right out of holders.
7	Disconnect electrical connector (4) at left or right.
8	Unscrew bolts (2).	Bolt, suspension strut to front axle/frame	*BA32.25-P-1001-04R
9	Pull suspension struts at front (1) left or right out of holders and remove downwards.
10	Install in reverse order.

Fig 2: Identifying Support Plate (000 588 10 62 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Major Assembly Mount (000 588 11 62 00)

Courtesy of MERCEDES-BENZ USA