Shock Absorber - Checking leaktightness and condition - AP32.25-P-3254G

Model 460, 461 

Model 463 up to model year 2019 

MODIFICATION NOTES

18.03.2008	Raise vehicle using vehicle lift, added	Operation step 1
01.01.1970	"Lower vehicle" added	Operation step 6

	Check
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
1	Raise vehicle with vehicle lift Lift/jack up vehicle		AR00.60-P-1000G
2	Check seals of piston rods	Oil must not leak out at the seals. Oil vapor in the area of the seals is safe.
3	Check rubber mounts	Rubber mounts must not be cracked, spongy, swollen or chafed. They must be free of any oil and grease.
4	Check for proper mounting of shock absorber on front axle and vehicle frame	Nut, shock absorber to front axle	*BA32.25-P-1001-01D
		Bolt, shock absorber to frame	*BA32.25-P-1002-01D
5	Check for proper mounting of shock absorber on rear axle and vehicle frame	Bolt, shock absorber to rear axle	*BA32.25-P-1001-03E
		nut, shock absorber to frame	*BA32.25-P-1002-03E
6	Lower vehicle

FRONT AXLE SHOCK ABSORBER

Number	Designation			Model 460, 461, 463
BA32.25-P-1001-01D	Nut, shock absorber to front axle	M12x1, 5	Nm	55
		M14x1, 5	Nm	70

REAR AXLE SHOCK ABSORBER

Number	Designation			Model 460, 461 Model 463 up to model year 2019	Model 463 as of model year 2019
BA32.25-P-1001-03E	Bolt, shock absorber to rear axle	M16x1.5	Nm	170	-

FRONT AXLE SHOCK ABSORBER

Number	Designation				Model 460, 461, 463
BA32.25-P-1001-03E	Bolt, shock absorber to frame	Outside diameter of bushing 21 mm	M16x1, 5	Nm	130
		Outside diameter of bushing ≥ 22 mm	M16x1, 5	Nm	170

REAR AXLE SHOCK ABSORBER

Number	Designation			Model 460, 461 Model 463 up to model year 2019	Model 463 as of model year 2019
BA32.25-P-1002-03E	Nut, shock absorber to frame	M12x1.5	Nm	55	-
		M14x1.5	Nm	70	-