Remove/Install Rear Door Lining - AR72.12-P-1010GW

Model 463 (except 463.202/342) 

as of model year 2013 up to model year 2019 

Courtesy of MERCEDES-BENZ USA

Fig 1: Rear Door Lining Components Location - Model 463 (Except 463.202/342) As Of Model Year 2013 Up To Model Year 2019

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
1	Remove screw (1) with countersunk washer from door lining (2)
2	Remove covers (3)	Mounting wedge	Fig 2
3	Remove screws (4)
4	Unclip door lining (2) from rear door at mounting clips (arrows)	Position assembly wedge, in each case, directly on mounting clips (arrows). Otherwise, the retaining tabs on the mounting clips (arrows) can tear out of door lining (2). Check mounting clips (arrows) for damage replace if necessary. Mounting wedge	Fig 2
5	Detach door lining (2) from rear door; in this connection, guide lock button (5) out of door lining (5)	Remove door lining (2) from rear door until electrical connectors and cable of inside door opener (6) can be accessed.
6	Unhook cable of inside door opener (6)
7	Disconnect electrical connector
8	Remove door lining (2)
9	Check door foil on the rear door	Check door foil, replace if necessary. Otherwise moisture can penetrate into the passenger compartment.
10	Install in the reverse order

Fig 2: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA