Wiring Diagram Of Backup Assist (BA) - PE54.65-P-2100-99A
MODEL 463 up to 31.5.12 with CODE (J44) Ultrasonic backup assist
| Code: | Designation: | Position: |
|---|---|---|
| A43 | Rear bumper PTS sensor unit | 44P |
| A43 | Rear bumper PTS sensor unit | 46P |
| A43 | Rear bumper PTS sensor unit | 49P |
| A43 | Rear bumper PTS sensor unit | 51P |
| A44/1 | BA [RFH] warning indicator | 4A |
| E7 | Backup lamp | 140 |
| F1 | Fuse box | 24M |
| K26 | Wiper system relay | 22M |
| M6/1 | Wiper motor | 210 |
| N62 | BA [RFH] control unit | 10A |
| N62 | BA [RFH] control unit | 24A |
| N62 | BA [RFH] control unit | 35A |
| N62 | BA [RFH] control unit | 49A |
| R2/3 | Right washer nozzle heater | 29M |
| R31 | Variant coding resistor (1000 ohms) | 37P |
| S16/10 | Gear recognition switch (voltage coded) | 17M |
| S2/1 | Ignition/starter switch | 25J |
| S4x1 | Combination switch connector | 21M |
| S9/1 | Stop lamp switch | 27M |
| U12 | Valid for left-hand drive vehicles | 190 |
| U12 | Valid for left-hand drive vehicles | 27L |
| U13 | Valid for right-hand drive vehicles | 19M |
| U13 | Valid for right-hand drive vehicles | 28L |
| U190 | Valid for APS | 16P |
| U54 | Valid for trailer hitch | 30J |
| W30 | Ground (frame) | 13P |
| W30 | Ground (frame) | 15P |
| W30 | Ground (frame) | 32K |
| X12/3 | Circuit 30, 15, 61 terminal block (3-pin) | 24J |
| X24/5 | APS/MWH [HLS] connector | 160 |
| X26/26 | BA [RFH] connector | 12F |
| X26/26 | BA [RFH] connector | 35F |
| X26/27 | Rear bumper sensors connector | 43H |
| X35/27 | BA [RFH] warning element intermediate connector | 2K |
| X58 | Trailer hitch socket (13-pin) | 320 |
| X60/3 | High/low tone setting connector | 39J |
| X92/3 | Frame connector (22-pin) | 17H |
| Z36/1 | Ground connector sleeve for sensors (backup assist in rear) | 53L |
| Z36/2 | Sensor voltage supply connector sleeve (backup assist in rear) | 52J |
| Z50/1 | Connector sleeve 1 | 28M |