Remove/Install Washer Fluid Reservoir Of Windshield Washer System - AR82.35-P-6000GW

Model 463 

as of model year 2013 up to model year 2019 

/facelift 2012 

Fig 1: Washer Fluid Reservoir Of Windshield Washer System Components Location - Model 463 As Of Model Year 2013 Up To Model Year 2019 /Facelift 2012

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Detach right front wheel
	Remove/install wheels, rotate if necessary		AP40.10-P-4050G
	Remove right wheel housing paneling
	Unscrew nut (3) from filler neck (4)
	Pull filler neck (4) from washer fluid reservoir (8)	: When installing the filler neck (4), check that the sealing ring is seated correctly on the washer fluid reservoir (8).
	Remove screws (9) of washer fluid reservoir (8)	There are 3 screws (9) present in total
	Disconnect electrical connectors	Electrical connectors of: windshield washer system pump (M5/1), headlamp cleaning system pump (M5/2) and windshield washer system washer fluid level switch (S42).
	Lift washer fluid reservoir (8) from wheel well and empty washer fluid	Pour washer fluid into a suitable vessel. : Only fill washer fluid after the operations have been completed.
	Mark hoses (5) and washer fluid pump (M5/1)
	Detach hoses (5) from washer fluid pump (M5/1)
	Remove hose (7) from headlamp cleaning system pump (M5/2)	To do so, detach clip (6) and remove hose.
	Install in the reverse order
	Pour in washer fluid	See owner's manual.
	Perform function test of the windshield washer system