(Remove/Install APS Radio And Navigation Control Unit - AR82.61-P-7412G)

Model 463 up to 11/30/00 

up to model year 2013 

with code EF1 (MB Audio 10 RDS radio with cassette deck) 

Model 463 up to 11/30/00 

up to model year 2013 

with code EF2 (Radio Audio 10 with single CD player) 

Model 463 up to 11/30/00 

up to model year 2013 

with code EF3 (Audio 30 RDS) 

Model 463 up to 11/30/00 

up to model year 2013 

with code ET6 (Auto Pilot System (APS)) 

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Pull out radio and navigation control panel	Press in radio and navigation control panel only at marked areas (A) applying a maximum force of 100N. The radio and navigation control panel could be damaged. To do so, insert removal tools (4). Push back retaining springs (arrow) on removed radio, then pull out removal tools (4). WH58.30-Z-1005-19A
2	Disconnect electrical connectors (1 to 3) on back of radio and navigation control panel (A2/29)	Do not kink or stretch fiber-optic cable D2B (2). The fiber-optic cable may be damaged.
3	Install in the reverse order
4	CODE RADIO	Coding radio	AR82.60-P-7502-01M
		Coding radio	AR82.60-P-7502-01B
		Configure radio and navigation control unit (APS) When replacing the radio, the device must be re-activated and the radio code entered. If installing the same device only the radio code has to then be activated. See: ↓ If it is replaced by a radio with navigation control panel (code ET6), the device must be reconfigured and the radio code activated. If installing the same device only the radio code has to then be activated. See: ↓ Voice output is automatically loaded within a period of 20 minutes after the radio and navigation control panel are connected. ↓	AR82.61-P-7412-02G