140 589 10 15 00 Drift - WS35.00-P-0149C
Model 129, 140, 166, 167, 170, 171, 172, 199, 202, 203, 204, 205, 207, 208, 209, 210, 211, 212, 213, 215, 217, 218, 219, 220, 221, 222, 230, 231, 253, 292, 447, 448, 636, 639
Use in FG 35/Set C
Purpose:
Ring gear Ø 198 mm: Drift for driving in the shaft seal for the connecting flange.
Ring gear Ø 200 mm (FE): Drift for driving in the side radial shaft sealing rings.
Ring gear Ø 210 mm (E): Drift for driving in the side radial shaft sealing rings.
NOTE:
In combination with W 203 589 01 14 00 sleeve.
W 203 589 01 14 00 sleeve is not required on model 447, 448, 636, 639.
W 203 589 01 14 00 sleeve is not required on model 447, 448, 636, 639.