Remove/Install Parking System Control Unit - AR54.65-P-0018LWE

Model 213 with code 220 (PARKTRONIC system (PTS)) 

Model 213 with code 235 (Parking Pilot with PARKTRONIC) 

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on HANDS-FREE ACCESS		AH80.61-P-0001-01A
	Remove/install
1	Commission parking system control unit (N62)	When replacing parking system control unit (N62).
			AD00.00-P-2000-04B
2.1	Remove left luggage compartment lining at side	Model 213.0/1 with code 220 (PARKTRONIC system (PTS)) Model 213.0/1 with code 235 (Parking Pilot with PARKTRONIC)	AR68.30-P-4800LWE
2.2	Remove left side load compartment lining	Model 213.2 with code 220 (PARKTRONIC system (PTS)) Model 213.2 with code 235 (Parking Pilot with PARKTRONIC)	AR68.30-P-1185LWE
3	Switch off ignition and store transmitter key outside of transmission range (at least 2 m)
4	Remove subwoofer from trunk	Model 213 with code 220 (PARKTRONIC system (PTS)) with code 811 (High-End sound system) Model 213 with code 235 (Parking Pilot with PARKTRONIC) with code 811 (High-End sound system) Model 213.0/1 with code 220 (PARKTRONIC system (PTS)) with code 811 (High-End sound system) Model 213.0/1 with code 235 (Parking Pilot with PARKTRONIC) with code 811 (High-End sound system)	AR82.62-P-7841LWE
5	Remove bolts (1), unscrew nuts (2) and remove bracket (3) with sound system control unit and place to one side	Model 213 with code 220 (PARKTRONIC system (PTS)) with code 810 (Premium sound system) Model 213 with code 220 (PARKTRONIC system (PTS)) with code 811 (black) Model 213 with code 235 (Parking Pilot with PARKTRONIC) with code 810 (Premium sound system) Model 213 with code 235 (Parking Pilot with PARKTRONIC) with code 811 (High-End sound system) The electrical connectors need not be detached.
6	Unscrew nuts (4), remove bracket (5) with control units and place to one side	Model 213 with code 220 (PARKTRONIC system (PTS)) with code 459 (Steel suspension with adjustable damping) Model 213 with code 220 (PARKTRONIC system (PTS)) with code 489 (AIRMATIC) Model 213 with code 235 (Parking Pilot with PARKTRONIC) with code 459 (Steel suspension with adjustable damping) Model 213 with code 235 (Parking Pilot with PARKTRONIC) with code 489 (AIRMATIC) The electrical connectors need not be detached. The number of control units installed on the holder (5) can vary depending on the vehicle equipment installed.
7	Unscrew nut (6), remove bolts (7) and remove bracket (8) with control units then place to one side	If installed. The electrical connections must be disconnected. The number of control units installed on the bracket (8) can vary depending on the vehicle equipment installed.
8	Remove bolts (9) and remove bracket (10)
9	Disconnect electrical connectors (11)	The number of electrical connections (11) may vary, depending on the vehicle equipment involved.
10	Unclip parking system control unit (N62) from bracket (10) (arrow) and take off
11	Install in the reverse order