Remove/Install Backup Camera - AR54.65-P-0030LWE
Model 213.0/1 with code 218 (Rear view camera)
Model 213.0/1 with code 501 (360° camera)
MODIFICATION NOTES
| 06.12.2019 | Calibration device added. | Step 13.2 |
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Notes on HANDS-FREE ACCESS | Model 213.0/1 with code 218 (Rear view camera) with code P17 (KEYLESS-GO package) Model 213.0/1 with code 501 (360° camera) with code P17 (KEYLESS-GO package) |
AH80.61-P-0001-01A | |
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
| 2 | Remove handle strip of trunk lid (2). | AR88.50-P-5062LF | |
| 3 | Remove trim from trunk lid (2). | AR68.30-P-8151LWE | |
| 4 | Push back protective sleeve (7) and detach electrical connection (6). | ||
| 5 | Remove nuts (3). | ||
| 6 | Remove handle (1) far enough from trunk lid (2) to gain access to the electrical connectors (4, 5). | ||
| 7 | Release and disconnect electrical connectors (4, 5) then remove handle (1). | ||
| 8 | Release and fold up retaining clamp (8). | ||
| 9 | Use suitable screwdriver (9) to remove retaining clamp (8) from handle (1). | ||
| 10 | Pull reversing camera (B84/3) or camera for rear 360° camera (B84/10) out of handle (1). | ||
| 11 | Install in the reverse order. | ||
| Initial startup | |||
| 12 | Commission reversing camera (B84/3) using vehicle diagnosis system. | Model 213.0/1 with code 218 (Rear view camera) except code 235 (Active Parking Assist) When replacing reversing camera (B84/3). | |
| AD00.00-P-2000-04B | |||
| Calibrate | |||
| 13.1 | Calibrate rear 360° camera (B84/10) or reversing camera (B84/3) using diagnostic system. | Model 213.0/1 with code 218 (Rear view camera) with code 235 (Active Parking Assist) Model 213.0/1 with code 501 (360° camera) |
|
| AD00.00-P-2000-04B | |||
| 13.2 | Calibrate reversing camera (B84/3) with vehicle diagnosis system. | Model 213.0/1 with code 218 (Rear view camera) except code 235 (Active Parking Assist) | |
| AD00.00-P-2000-04B | |||
| Fig 1 |