LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2018 >> E300 Base >> Repair and Diagnosis >> Body & Frame >> Sun Roof/T-Top/Convertible Top >> Sliding Roof, Soft Top, Top Attachments - 213 Chassis >> Testing & Repair >> Adjust Tilting/Sliding Roof Panel - AR77.20-P-1100LW

Adjust Tilting/Sliding Roof Panel - AR77.20-P-1100LW

Model 205.0/1 

with code 414 (Sliding sunroof) 

Model 213.0/1/2 

with code 414 (Sliding sunroof) 

Shown on right side of vehicle 

G13747360Courtesy of MERCEDES-BENZ USA
G13747361Courtesy of MERCEDES-BENZ USA
WARNING Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. No parts of the body or limbs should be within the operating area when the components are moving. AS00.00-Z-0011-01A
REMOVING Remove     
1 Connect diagnostic system and normalize sliding roof    
REFER TO SELF-DIAGNOSTIC SYSTEMS     AD00.00-P-2000-04B
2 Open sliding roof paneling (3)    
3 Remove left and right boot (2) NOTES
Extend left and right boot (2) first at bottom and then at top.
Otherwise the left and right boot (2) can be damaged by bending.
 
  Adjust     
4 Loosen bolts (4) on left and right sliding roof glass cover (1)    
5 Push sliding roof glass cover (1) upward out of sliding roof cutout    
6 Lower sliding roof glass cover (1) back into sliding roof cutout IMPORTANT The sliding roof glass cover (1) is centered by the pressure of the sliding roof seal in the sliding roof cutout.  
7 Adjust sliding roof glass cover (1) in relation to left and right front roof paneling and tighten front bolts (4) IMPORTANT Observe position of measuring position (A when adjusting height.
Sliding roof adjustment
*BE77.20-P-1001-01H 
8 Adjust sliding roof glass cover (1) in relation to left and right rear roof paneling and tighten > rear bolts (4) IMPORTANT Observe position of measuring position (A when adjusting height.
Sliding roof adjustment
*BE77.20-P-1001-01H 
9 Tighten center bolts (4)    
INSPECT Check     
10 Move sliding roof glass cover (1) to tilt position    
11 Move sliding roof glass cover (1) from tilt position to open position IMPORTANT Do not open sliding roof glass cover (1) completely.  
12 Close sliding roof glass cover (1) "    
13 Check adjustment of sliding roof glass cover (1) at all 4 measuring positions (A) If adjustment is not correct.

Repeat adjustment of corresponding measuring position (A).
 
INSTALLING Install     
14 Install left and right boot (2)    
15 Closing sliding roof paneling (3)    
SLIDING ROOF TEST AND ADJUSTMENT VALUES

Number Designation Model 205 Model 213
BE77.20-P-1001-01H Sliding roof adjustment Measurement position "A" (x) mm 140 140
Front: Lower than roof paneling mm 0...1 0...1
Rear: Higher than roof paneling mm 0...1 0...1