Remove/install left front or right rpm sensor - AR42.30-P-0712RK

MODEL 231 

Shown on vehicle with CODE 487 (Active Body Control (ABC)) 

Fig 1: Left Front Or Right RPM Sensor Remove/Install Components - Shown On Vehicle With Code 487

Courtesy of MERCEDES-BENZ USA

Shown on vehicle without CODE 487 (Active Body Control (ABC)) 

Fig 2: Left Front Or Right RPM Sensor Remove/Install Components - Shown On Vehicle Without Code 487

Courtesy of MERCEDES-BENZ USA

	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
	Remove/install
1	Lift vehicle on vehicle lift		AR00.60-P-1000TX
2	Remove front wheel		AP40.10-P-4050EW
3	Remove fender liner of the front fender	Rear section is sufficient.	AR88.10-P-1300RK
4	Disconnect front axle electrical connection, left distributor (X62/7) or BWI [BBV]/rpm right front axle electrical connection (X62/36)
5	Unclip electrical line (1) from left front axle rpm sensor (L6/1) or right front axle (L6/2) at the line brackets (2)	Pay attention to installation of lines.
6	Remove screw/bolt (4) and pull out left front axle rpm sensor (L6/1) or right front axle rpm sensor (L6/2) from steering knuckle (3)	Self-locking bolt, rpm sensor on front axle to steering knuckle	*BA42.30-P-1001-01A
7	Install in the reverse order
8	Connect STAR DIAGNOSIS, read out fault memory and erase if necessary		AD00.00-P-2000-04A