Remove/install side flap limit switch (folded in) - AR77.39-P-3697RK
MODEL 231
| Risk of injury. Moving parts can pinch, crush or, in extreme cases even sever extremities. | No parts of the body or limbs should be within the operating area of the mechanism when the components are moving. | AS00.00-Z-0009-01A | |
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notes on sensor system for trunk lid opening/closing | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Open trunk lid (1) | ||
| 2 | Switch off ignition and remove transmitter key (A8/1) or KEYLESS-GO start/stop button (S2/3) from electronic ignition lock control unit (N73) | ||
| 3 | Unscrew bolts (3) and remove side flap fold-in/out limit switch (S120/2) | ||
| 4 | Disconnect electrical connector on side flap fold-in/out limit switch (S120/2x1) and remove side flap fold-in/out limit switch (S120/2) | ||
| 5 | Install in the reverse order |