Remove paneling in trunk - AR68.30-P-4600RK

MODEL 231 

Shown on removed trunk floor paneling (5) 

Fig 1: Trunk Paneling Related Components - Shown On Removed Trunk Floor Paneling

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Notes on sensor system for trunk lid opening/closing		AH80.61-P-0001-01A
	Remove/install
1	Remove left and right paneling in trunk		AR68.30-P-4800RK
2	Remove retaining clips (4)
3	Pull cover (3) with pin out of radio holder (2)	For this purpose unclip cover (3) from radio holder (2) at both sides (arrows) with suitable screwdriver.
4	Remove radio holder (2)
5	Remove center trunk paneling (1)
6	Install in the reverse order