Remove/install wiper system - AR82.30-P-6400LF
MODEL 217, 222
MODIFICATION NOTES
| 10.06.2016 | Tightening torque - added | Operation step 5 | |
| 14.06.2016 | Bolt, reinforcement to firewall/longitudinal member/reinforcement, center | BA62.25-P-1001-01B |
Shown on model 222
| Injury hazard from pinching and crushing, in extreme cases extremities can even be cut off when caught in windshield wiper mechanism. | When working on the windshield wiper mechanism, always switch off the ignition and store transmitter key outside of transmission range (at least 2 m). | AS82.30-Z-0001-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Remove wiper arms | AR82.30-P-6100LF | |
| 2 | Remove cover (2) | ||
| 3 | Remove bolts (3) | ||
| 4 | Remove strut (4) | ||
| 5 | Unscrew bolts (6, 7) | *BA62.25-P-1001-01B | |
| 6 | Remove strut (5) | ||
| 7 | Remove bolt (8) | *BA82.30-P-1001-01P | |
| 8 | Lift up windshield wiper system (1) and disconnect electrical connector from motor on windshield wiper system (1) | ||
| 9 | Remove windshield wiper system (1) | ||
| 10 | Install in the reverse order | ||
| Check | |||
| 11 | Check wiper arms and adjust | Model 217 Model 222 with code 874 (MAGIC VISION CONTROL, heated) |
AR82.30-P-6000LC |
| Model 222 except code 874 (MAGIC VISION CONTROL, heated) |
AR82.30-P-6000GZ |
FIREWALL
| Number | Designation | Model 217 | Model 222 | ||
|---|---|---|---|---|---|
| BA62.25-P-1001-01B | Bolt, reinforcement to firewall/longitudinal member/reinforcement, center | M6 | Nm | 9 | 9 |
| M8 | Nm | 30 | 30 | ||
WINDSHIELD WIPER
| Number | Designation | Model 217 | Model 222 | ||
|---|---|---|---|---|---|
| BA82.30-P-1001-01P | Screw/bolt, windshield wiper system to body | M8 | Nm | 11 | 11 |