Remove/install wiper arm - AR82.30-P-6100LF
MODEL 217, 222
Shown on model 222
| Injury hazard from pinching and crushing, in extreme cases extremities can even be cut off when caught in windshield wiper mechanism. | When working on the windshield wiper mechanism, always switch off the ignition and store transmitter key outside of transmission range (at least 2 m). | AS82.30-Z-0001-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch on ignition and store transmitter key outside of transmission range (min. 2 m) | ||
| 2 | Remove covers (1) | ||
| 3 | Disconnect electrical connector (2) or electrical connector (3) | ||
| 4 | Disconnect hose coupling (4) or hose coupling (5) | ||
| 5 | Remove covers (6) or cover (7) and unscrew nuts underneath | *BA82.30-P-1002-01P | |
| 6 | Remove driver-side wiper arm (9) and passenger-side wiper arm (8) | ||
| 7 | Unclip wiring harness of the driver-side wiper arm (9) or passenger-side wiper arm (8) from the respective mounting clamps and route through opening in the air-water duct (10) | ||
| 8 | Install in the reverse order | ||
| Check | |||
| 9 | Check and adjust wiper arms (8, 9) | Model 222 except code 874 (MAGIC VISION CONTROL, heated) |
AR82.30-P-6000GZ |
| Model 217 Model 222 with code 874 (MAGIC VISION CONTROL, heated) |
AR82.30-P-6000LC |
WINDSHIELD WIPER
| Number | Designation | Model 217 | Model 222 | ||
|---|---|---|---|---|---|
| BA82.30-P-1002-01P | Nut, wiper arm to windshield wiper system | M10 | Nm | 30 | 30 |