Align End Stops For Soft Top Supports - AR77.30-P-0002-01LWR

WARNING: This page is about a different car, the 2023 Mercedes-Benz C63 S AMG, 2021 Mercedes-Benz C63 S AMG, 2021 Mercedes-Benz C63 AMG, 2020 Mercedes-Benz C63 S AMG, and 2020 Mercedes-Benz C63 AMG. However, it is still accessible from the selected car via links, so may be relevant.

Model 205.4

Model 238.4

MODIFICATION NOTES

26.01.2017

Special tool for adapter set added

MECHANICAL SOFT-TOP COMPONENTS

Number	Designation		Model 205.4
BA77.33-P-1002-02B	Bolt, mounting plate to body	Nm	10

MECHANICAL SOFT-TOP COMPONENTS

Number	Designation		Model 238.4
BA77.33-P-1002-02C	Bolt, mounting plate to body	Nm	10

Fig 1: Identifying Device (217 589 00 31 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Adapter Kit (205 589 01 31 00)

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

Assemble device (1) with adapters as shown (10) and adjust sliding pieces (2) to corresponding markings.

Courtesy of MERCEDES-BENZ USA
Lay device (1) together with sliding pieces (2) down on rear fenders (3) and with bolts (4) on windshield frame (5).
Carefully lay down device (1).

Otherwise the paint and detachable parts can be damaged.

Helper required.
Align device (1) with fit bolt (6) in center on windshield frame (5) and fix in place.
Screw in bolts (7) on left and right outside of windshield frame (5) into bolts (4)
The end stops (8) must make contact with the windshield frame (5).
Insert left and right end stop (9) for soft top support in adapters (10), slide forward until end stop (arrows) and tighten screws (11). Model 205.4
Model 238.4
Remove device (1).
Carefully move out device (1) and remove. Otherwise the paint and detachable parts can be damaged.

Helper required.
Disassemble device (1).