Remove/Install Handle On Roof - AR68.30-P-4330NKB

WARNING: This page is about a different car, the 2023 Mercedes-Benz C63 S AMG, 2021 Mercedes-Benz C63 S AMG, 2021 Mercedes-Benz C63 AMG, 2020 Mercedes-Benz C63 S AMG, and 2020 Mercedes-Benz C63 AMG. However, it is still accessible from the selected car via links, so may be relevant.

Model 117, 156, 176, 205, 213, 222, 242, 246, 253, 293

Shown on model 246

Fig 1: Roof Grab Handle Component Location - Model 205 (Shown On Model 246)

Courtesy of MERCEDES-BENZ USA

	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove
1	Remove covers (2).
2	Press together clips (3) and remove grab handle (1).
3	Release and disconnect electrical connector of rear illumination at rear grab handle (1).	Model 156 with code 413 (Automatic panoramic sliding sunroof) Model 205, 253, 293 with code 876 (Interior Light package) Model 213, 222
4	Remove clamps (3) from the body.
	Install
5	Clip clamps (3) and covers (2) into the grab handle (1).
6	Connect electrical connector of rear illumination at rear grab handle (1).	Model 156 with code 413 (Automatic panoramic sliding sunroof) Model 205, 253, 293 with code 876 (Interior Light package) Model 213, 222
7	Clip grab handle (1) into the roof.
	Check
8	Check grab handle at roof.		AR68.30-P-4330-01NKB