Remove/Install Cover On Stowage Box - AR68.20-P-1020LW
WARNING: This page is about a different car, the 2023 Mercedes-Benz C63 S AMG, 2021 Mercedes-Benz C63 S AMG, 2021 Mercedes-Benz C63 AMG, 2020 Mercedes-Benz C63 S AMG, and 2020 Mercedes-Benz C63 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 205, 253, 293
Model 213, 238 with transmission 716
Shown on model 253 with transmission 725
Fig 1: Cover On Stowage Box Component Location - Model 205 (Shown On Model 253 With Transmission 725)
Shown on model 205.4
| Remove | |||
| 1 | Switch off ignition. | ||
| 2 | Open armrest cover (2). | ||
| 3 | Pull stowage box cover (1) at front upwards until retaining clips (11, 12) tangibly release. | ||
| 4 | Insert extraction hook (4) behind hinge (5) at side between left armrest cover (2) and center console (3) and release retaining tab (9) by pressing. | Fig 2 | |
| 5 | Insert extraction hook (4) behind hinge (6) at side between right armrest cover (2) and center console (3) and release retaining tab (10) by pressing. | Fig 2 | |
| 6 | Pull stowage box cover (1) upwards. | ||
| 7 | Press in locks (7, 8) and remove stowage box cover (1). | ||
| 8 | Disconnect connector (13). | Model 205.4 | |
| 9 | Unscrew screws (14) and remove soft top control switch (S84). | Model 205.4 When replacing stowage box cover (1). |
|
| Install | |||
| 10 | Position soft top control switch (S84) at stowage box cover (1) and tighten screws (14). | Model 205.4 When replacing stowage box cover (1). |
|
| 11 | Connect connector (13). | Model 205.4 | |
| 12 | Position stowage box cover (1) in installation position and clip in. | ||
| 13 | Close armrest covers (2). |