Modify Side Paneling In Rear For Draft Stop - AN77.25-P-2199-01LWR
WARNING: This page is about a different car, the 2023 Mercedes-Benz C63 S AMG, 2021 Mercedes-Benz C63 S AMG, 2021 Mercedes-Benz C63 AMG, 2020 Mercedes-Benz C63 S AMG, and 2020 Mercedes-Benz C63 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 205.4
Modification shown on right side paneling.
Modification on left side paneling analogously.
- Measure center point on present marking (1) on side paneling (2) and mark.
- Drill through marked center point.
Use commercially available drill bit 0 5 mm.
- Drill hole in side paneling (2) from inside to approx. 35 mm.
- Cut in extending cover (3) of side paneling (2) several times.