Prepare Window For Installation - AR67.10-P-1000-03RG

Model 190 

The bonding area on the window must be absolutely free of dust and grease.

Otherwise the adhesive force of the adhesive material starts to decrease when installing window.

1. 1. Check window for scratches and damage, replace if necessary.
2. 2.1 When reusing removed windshield

   Cut off residual adhesive material on windshield with scraper down to a height of approx. 2 mm. Remove adhesive material residues.

3. 2.2 When installing removed windshield

   Clean bonding area on windshield using cleaner from repair kit and rub dry with rag.

   Observe processing instructions for primer to prevent adhesion problems with the adhesive material when installing the window.

4. 3.1 When reusing removed windshield

   Repair damaged primer layer on windshield with primer included in repair kit.

5. 3.2 When installing removed windshield

Coat bonding area on windshield with primer included in repair kit (with max. 20 mm).

Windshields are generally delivered with a viewing window on the bottom left. If the viewing window is not required, coat this area on the inside of the window with primer.