Retrofit Incar Hotspot Holder - AZ82.80-P-0002-02GQX

MODEL 166.8 

1. Read off "WPA" number on model plate of In Car Hotspot (1) and note on rear page of operator's manual.

   The operator's manual is included in the installation kit. Only note the "WPA" number if this has not yet been attached to the rear of the operator's manual in the form of a sticker.

   Courtesy of MERCEDES-BENZ USA

2. Mount holder (13), as shown, to In Car Hotspot (1).

   Courtesy of MERCEDES-BENZ USA

3. Mount holder (13) with In Car Hotspot (1), as shown, onto propeller shaft tunnel.

   Courtesy of MERCEDES-BENZ USA