Retrofit Electrical Wiring Harness For CA Module Card Reader - AZ82.60-P-0032-01GQ
Model 166
Model 292
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A |
- Connect blue 1-pin connector (5.1) at tuner unit (A90/4).
- Raise mounting brackets (arrows) of control unit carrier.
- Route wiring harness (5), as shown, under mounting brackets (arrows) to installation location of CA module card reader in center console.
Note extended length of wiring harness (5) for connection at CA module card reader.
Blue 1-pin connector (5.2) is connected to CA module card reader at a later point in time.